Boat repair aplications

Timbabuild Epoxy Wood Stabiliser is a specially designed two-part low viscosity, solvent free, resin solution which is designed to strengthen weakened wood fibres by penetrating deep into the wood. The product is used as a primer in conjunction with the Epoxy Rapid Cure (E.R.C.) or Epoxy High Build (E.H.B.) systems. Once the damaged, decayed and discoloured wood has been removed by use of a suitable cutter tool such as a router or chisel, then the area to be treated is lightly sanded to ensure excellent adhesion. The moisture content of the wood should be no greater than 18% (check using a standard moisture meter) and damp wood should be allowed to dry naturally, or by way of a hot air gun. The two components are mixed manually into a separate container, and thoroughly agitated for one minute. The 2:1 mixing ratio should be strictly observed. E.W.S. should be applied using a standard brush and left to cure for 30 minutes.

Timbabuild Epoxy High Build (EHB) is a two-part thixotropic 3:1 ratio mix solvent free, epoxy based woodfiller. It is specially designed for large and extensive repairs of damaged and rot affected timber in both horizontal and vertical applications. E.H.B. displays high strength and impact resistance.
E.H.B. is supplied in a specially designed side-by-side cartidge that fits into a custom made gun accurately dispensing the filler. Once cured, Epoxy High Build can be machined, drilled and accepts nails, screws etc. E.H.B. can be coated with most decorative wood finishes.
The special ?non-slump? formula allows it to seamlessly replace large sections of wood in aplpications such as windows, doors, beams, gutters, soffits and fascias.

Timbabuild Epoxy Rapid Cure (ERC) is a two-part 1:1 ratio mix solvent free, rapid curing, epoxy based woodfiller. It is specially designed for small repairs to timber which are subject to stress and impact. Its excellent structural strength and adhesion also enables it to be used as an adhesive. E.R.C. is supplied in a specially designed side-by-side cartidge that fits into a custom made gun accurately dispensing the filler. A unique nozzle attached to the end of the cartridge may be used to blend the base and activator components fully to ensure an accurate mixing. Once cured, Epoxy Rapid Cure can be machined, drilled and accepts nails, screws etc. E.R.C. can be coated with most decorative wood finishes.